See Below For Matching Tops: Lightweight Roller Tip-Tops

Versatile AFTCO Lightweight Guides bring new standards of guide performance to a wide range of FRESH AND SALTWATER rods designed for 2 to 30-lb. test lines. They are LIGHTER than ring guides, yet TWICE AS TOUGH! With rugged graphite composition frames and pure titanium guards and rollers, Lightweight Guides are virtually unbreakable, and their single-foot design and ultra-light weight in no way inhibit the action of lighter graphite and fiberglass blanks. In fact, Lightweight Guides cast every bit as far and as accurately as "ring" guides, while at the same time, offering the ultimate in line-wear protection with their "roller guide" design. Lightweight Guides require virtually no maintenance, and are available in Black Frames, with your choice of Silver, Black, or Gold guards.

Lightweight Roller Tip-Tops can be affixed to the blank with a good epoxy or "hot melt" top glue, providing your glue's melting point does not exceed 300 degrees F. A small propane or gas torch may be used to heat the tube before fitting it into the blank, but be careful -- over-heating can melt the tube. With a little practice, the proper amount of heat can be applied with no damage to the top tube.